I had to take one of the vent off the tank,it just didnt do ot for me,got a 60mm alu tube and im going to insert a plasma water gauge in to it,have to get the alu welded into the tank,it will sit over the tank breather tube,the wires will run inside the pipe,
Also might have to split the mask down the center to make it wider by about an inch or two,looks to small beside the forks,
Have some pic,s down below,it will sit over the breather,
Also week week ill have the warning lights put in the petrol cap,,then the tank will be finish i hope,
Linear Mode
